Will this fit my Kat? (stator cover)

Parts fiche browsing seems to indicate the same cover was used 80 - 82 so I'm guessing it's good to go for a fit. 83 changed but maybe that was from clear alloy/silver finish to black?
 
The black one is the same but black... :roll: I have the black one on my motor only its silver...

I stripped the black off with Loctite gasket remover and what you see is what is underneath the black... a perfectly good silver one.

The black one was cheaper than the silver one.
 
Cool Reg, I reckon I'll stick my mitt in my pocket for this one and give it a crack.
 
Turns out the answer is no... arrived today and it's the small stator mount like the Kat cover. Not the seller's fault, I took a gamble.

Anyone need a cover?
 
Will do! I know Aaron has GSX covers around so I should be able to get one from him, didn't realise that until after I'd bought this one... you get that.
 
Will do! I know Aaron has GSX covers around so I should be able to get one from him, didn't realise that until after I'd bought this one... you get that.
here are some cover shots
IMG_2136.jpg IMG_2135.jpg
the top cover suits the 1100
I past this on already
don't know what the lower cover suits,
it is excess to my requirements,
I swaped a new bigger ID stator for it a while back
thats another story,
though it has a spare Katana stator in it
should the new one I put in
a few years ago fail.
As for wiring the stator to the rec/reg
here is what I recommend to do
dont leave or put the third wire via the head light switch
have all three wires from stator direct to the rec/reg, cheers.
IMG_2260.jpg.
 
Last edited:
Cheers Pat, I'll chase up Aaron this week as he's just up the road (no postage that way), I think it's easy enough sorted... as for the wiring, yep, 100% with you stator direct to R/R. Have the wee beastie set up that way and the Kat will be the same for sure.
 
So.... anyone need a stator cover? Aaron's got a GSX one I can buy off him, will need to offload this one though.
 
Hi Pete I have the slightly cracked one from when my 1100 fell off the stand. You can have it for nix but you'll need to get the crack fixed
 
Cheers for the offer Paul but that's a proper Kat one for the small stator/rotor right? I need the larger GSX version... which is why I bought this one... but turns out it's the smaller Kat version...
 
Cheers for the offer Paul but that's a proper Kat one for the small stator/rotor right? I need the larger GSX version... which is why I bought this one... but turns out it's the smaller Kat version...

Pete, I thought you had this organised. I have a new one in storage but for the life of me cannot remember which model. Tomorrow evening I will go for a dig and let you know.
 
I walked away from my desk and went digging (far more interesting than an audit report). I do have a new silver alternator cover with a 35mm stator mount. Let me know if that is what you need.
 
Sorry Tom, should've clarified in my reply to Paul... Aaron's got me covered (haha) with a suitable GSX cover :)

I only bumped the thread the other day as I need to offload this one, probably should stick it in the parts for sale section...
 
Sorry Tom, should've clarified in my reply to Paul... Aaron's got me covered (haha) with a suitable GSX cover :)

I only bumped the thread the other day as I need to offload this one, probably should stick it in the parts for sale section...

Pete not a problem at all. Glad you are sorted
 
Back
Top Bottom